iptunnel(8) — Linux manual page


IPTUNNEL(8)                                                  IPTUNNEL(8)

NAME         top

       iptunnel - creates, changes, deletes, and displays configured

SYNOPSIS         top

       iptunnel [<operation>] [<args>]

NOTE         top

       This program is obsolete. Please use ip tunnel instead, and see
       ip-tunnel(8) for more information.

DESCRIPTION         top

       The iptunnel command creates configured tunnels for sending and
       receiving IPv6 or IPv4 packets that are encapsulated as the
       payload of an IPv4 datagram.

       The iptunnel command can perform one of the following operations:

       create - create a tunnel interface, which you must subsequently

       change - change an existing tunnel interface.

       delete - delete a tunnel interface. You must disable the tunnel
       before you can delete it.

       show - show the tunnel attributes (name, tunnel end points, next
       hop for tunneled packets).

SEE ALSO         top

       ip-tunnel(8), ip(8)

COLOPHON         top

       This page is part of the net-tools (networking utilities)
       project.  Information about the project can be found at 
       ⟨http://net-tools.sourceforge.net/⟩.  If you have a bug report for
       this manual page, see ⟨http://net-tools.sourceforge.net/⟩.  This
       page was obtained from the project's upstream Git repository
       ⟨git://git.code.sf.net/p/net-tools/code⟩ on 2021-04-01.  (At that
       time, the date of the most recent commit that was found in the
       repository was 2021-03-25.)  If you discover any rendering
       problems in this HTML version of the page, or you believe there
       is a better or more up-to-date source for the page, or you have
       corrections or improvements to the information in this COLOPHON
       (which is not part of the original manual page), send a mail to

                             SEPTEMBER 2009                  IPTUNNEL(8)