This manual page is part of the POSIX Programmer's Manual. The Linux
implementation of this interface may differ (consult the
corresponding Linux manual page for details of Linux behavior), or
the interface may not be implemented on Linux.
The siglongjmp() function shall be equivalent to the longjmp()
function, except as follows:
* References to setjmp() shall be equivalent to sigsetjmp().
* The siglongjmp() function shall restore the saved signal mask if
and only if the env argument was initialized by a call to
sigsetjmp() with a non-zero savemask argument.
After siglongjmp() is completed, program execution shall continue as
if the corresponding invocation of sigsetjmp() had just returned the
value specified by val. The siglongjmp() function shall not cause
sigsetjmp() to return 0; if val is 0, sigsetjmp() shall return the
Portions of this text are reprinted and reproduced in electronic form
from IEEE Std 1003.1, 2013 Edition, Standard for Information
Technology -- Portable Operating System Interface (POSIX), The Open
Group Base Specifications Issue 7, Copyright (C) 2013 by the
Institute of Electrical and Electronics Engineers, Inc and The Open
Group. (This is POSIX.1-2008 with the 2013 Technical Corrigendum 1
applied.) In the event of any discrepancy between this version and
the original IEEE and The Open Group Standard, the original IEEE and
The Open Group Standard is the referee document. The original
Standard can be obtained online at http://www.unix.org/online.html .
Any typographical or formatting errors that appear in this page are
most likely to have been introduced during the conversion of the
source files to man page format. To report such errors, see
IEEE/The Open Group 2013 SIGLONGJMP(3P)